electric motor scooter a layer of protective film

New and long mileage cars are required wear protection, security engine covered with a layer of protective film, effectively resist due to friction, damage caused by the operation. If we can stick to periodically do a few basic maintenance steps above, I believe that your motorcycle engine parts will be forever young and beautiful, street bike motorcycle as you fight "light" a lot.Motorcycle start moving without failure is often the case, I believe that every rider has encountered this embarrassing situation, even after several electric start has run out of battery charge remaining, electric motor scooter love horse still lying motionless rider anxious straight stamping did not help; especially after the middle of nowhere before the wilderness suddenly stalled unable to start, it is anxious like ants on a hot pan. wave110 cub motorcycle engine Under normal temperature conditions (-5 ℃ above), when the motorcycle engine start by 2-3 times and does not start, indicating the presence of a fault, the fault is nothing more than a circuit, oil and cylinder pressure three elements. As long as the oil flow, the circuit is normal, there is a certain pressure cylinder compression, the engine will be able to start working properly. Under normal circumstances, because no pressure cylinder failure (mainly crankcase, cylinder leakage, piston ring wear and electric scooter motor breakage caused by, check cylinder compression is good spark plug hole if they feel they have a violent impact, "pop" sound, fingers was the top open, that think the compression is good. otherwise, it is necessary "hospitalized") which led to the engine can not start a little, a lot of the fault lies in the circuit system, followed by the oil, so as long as we grasp this principle and try electric motor scooter using the following methods, in general, will be able to jump start a motorcycle.